Counter-Strike 2 setup guide

Pellix DMA

Hardware Setup & Configuration Guide

Only follow this guide if your order email says Pellix DMA.

Where your key goes

pellix.xyz

Do not enter this key on undetek.com or any other product's website. It will not work there.

Hardware Required: Pellix DMA needs a second PC, a DMA card, a Fuser for visuals and a MAKCU or KMBOX NET for aimbot and triggerbot.

DMA Setup

Hardware: Pellix lists: a second PC, a DMA card (Pellix recommends Spade Gear), a Fuser for visuals and a MAKCU or KMBOX NET for input. Connect your DMA card to the target PC (the PC running CS2) via a PCIe slot.
Register: On your second PC, create an account on the Pellix register page and confirm your registration via email.
Your key goes here Activate Key: Log in, find the "CS2 DMA" product in your personal account, click "Activate Key", enter your key and press "Activate".
Download: Download the DMA software from your Pellix dashboard on the second PC.
Run: Run the software as Administrator on your second PC.
Connect & Play: Launch CS2 on the target PC and connect through the DMA software.

Needs extra hardware: Aimbot and Triggerbot work only with a MAKCU or KMBOX NET. First shot delay works only with a MAKCU.

Not available on DMA: Aimbot assist mode, keyboard inputs (Bunnyhop, Perfect Defuse, Blockbot, Autostop, AntiAFK) and Auto accept.

Faceit: Pellix DMA runs on Faceit only if your DMA card firmware bypasses Faceit. Pellix does not sell or recommend such firmware.